The Effect Of The Stabilizer Bar Is Shown in The Side Of The Corner

The hardness of the balance rod is determined by the material made, the rod body, the rod diameter, the length of the rod arm, and the Angle formed by the rod body. The longer the length of the rod body, the softer the hardness, whereas the longer the length of the rod arm will increase its hardness. The length of the rod body can hardly be changed due to the width of the vehicle, but the diameter and length of the arm are relatively easy to adjust. Generally speaking, the material of the balance rod is much the same, so to change the hardness of the balance rod is achieved by changing the rod diameter.
In addition, due to the action of the lever principle, changing the connection point of the suspension arm and the balance rod arm can change the moment of the rod arm, and the adjustable balance rod is started here. In addition, changing the rubber lining for the balancing pole to a hard material can have a surprising effect. In actual tests, using a 0.8 "diameter pole with a hard liner has the same effect as using a 1.0" diameter pole with a rubber liner.
The effect of the Stabilizer Bar is displayed in the tilt of the corner, to understand the degree of tilt is the best way to use the camera to take the limit of the bending of the photo, and then measure the Angle of the roll on the photo, replace the harder Stabilizer Bar in the same way to take again, compare the Angle of the two can be judged different. To calculate the hardness of the required balance rod is very complicated, not only to consider its own hardness but also to consider the match with the spring, so only continuous testing and testing, which is the only way to set the chassis.
When you decide to modify your chassis, in addition to the spring and shock absorber collocation, you should also consider your balance rod, this knowledge is based on scientific theory, rich experience and continuous trial, and the real fun of modification is here.